Bendix-commercial-vehicle-systems SMARTIRE TPMS OPERATORS MANUAL Manual de usuario descargar pdf (Pagina 15)

IMPORTANT

READ THESE INSTRUCTIONS PRIOR TO INSTALLATION

This SmarTire

™

kit is pre-programmed and ready to use, subject to your application:

 Sensors have been PRE-ASSIGNED TO WHEEL POSITIONS and are identified on each

unit with a position label (P1, P2, P3, etc.) – install the sensors as per the diagram below.

 Default values have been assigned to each axle for the following:

o Cold Inflation Pressure (CIP) – 100 PSI

o First Alert Level (FAL) – set to a deviation of ±15% from CIP

o Second Alert Level (SAL) – set to -20% from CIP

o High temperature alert (optional) – ITEC specific kits set to OFF, all other kits

set to 85°C

Installation steps:

1. Install the receiver, display, antenna and harnesses on the vehicle, following the

instructions in “Section D – Installation Electrical” section of the SmarTire

™

manual.

2. Install the sensors in the pre-programmed locations as above, following the instructions in

“Section E – Installation Tire Sensors” section of the SmarTire

™

manual.

3. Adjust any system parameters as required, following “Section B – System

Programming” section of the SmarTire

™

manual.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

Sin comentarios

Bendix-commercial-vehicle-systems SMARTIRE TPMS OPERATORS MANUAL Manual de usuario Pagina 15